Signedstamped on top: O. Wolff Berlin
Inscribedon top: manganin
on side: H.U. / 111-A
FunctionA resistance standard is not to measure the resistance of an electric conductor but rather to compare such a conductor to a temperature-fixed resistance. In other words, such a device is used to determine the value of an unknown current. To do so, a current in the conductor would pass through mercury (for the older type of standard resistance), into which the two leads from the resistor dip. The manganin wire in this instrument was baked before being dipped into paraffin so that all moisture is removed and to improve the insulation over the wire.
This one was used with other similar resistances of different values and a bridge to connect several of them together.
From Card:
"Ref. An adaptation of the standard use in 1865 (See report Standards Committee - british 1873, p136.pl.4). At the time wire of 2/3 silver and 1/3 platinum were used. Coil surrounded by wire and suspended in water bath. (See also J.E.H. Gordon. Elec & Mag [London 1883] p.267. p321, pl.24). This variety has replaced the earlier form."
ProvenanceFrom the School of Engineering, Harvard University.